Take x4 18” pipes and slide them into the vertical holes of x4 Side Outlet Elbows (682-804HC) then tighten set screws.
Stage 2
Attaching Legs
Take x4 36” pipes and attach them to the open horizontal holes of the Side Outlet Elbows (682-804HC) to create a square then tighten set screws.
Stage 3
Prepping Horizontal Pipes
Take x5 36” pipes. Attach x3 Double Tab Offset Flanges (689-804HC) to one pipe, Two Offset Flanges (689-904HC) to two pipes and x1 Single Socket Tee (680-104HC) to two pipes
Center these appropriately then tighten set screws.
Stage 4
Attaching Vetical Pipes
This step involves building another square on the top except there is a middle pipe and all the pipes have fittings.
The pipe with x3 Double Tab Offset Flanges (689-804HC) is the middle pipe.
You will want the pipes with the Single Socket Tee (680-104HC) across from each other and the pipes with the Offset Flanges (689-904HC) across from each other.
Place the Side Outlet Elbows (682-804HC) on each vertical pipe then tighten set screws.
Build the top like you did before and match what you see in above line art.
Build a total of two bases for the table.
Stage 5
Attaching Wood Top
Use wood screws to attach the Double Tab Offset Flanges (689-804HC) and the Offset Flanges (689-904HC) to the wood piece.