Bathroom Shelf

Bathroom Shelf

Keep everything dry with this Bathroom Shelf! anything from your personal belongings to your towel.

Skill Level
Estimated Cost
Estimated Time

Tools & Materials

SteelTek Supplies (3/8"):

  • (4) Black Flange - (683-102HC)
  • (2) Single Socket Tee - (680-102HC)
  • (2) Elbow - (682-502HC)
  • (2) 18" Non Threaded Pipe - (582-180PE30HC)
  • (2) 6" Non Threaded Pipe - (582-060PE30HC)

Other Supplies:

  • Shelves
  • Wood Screws
  • Anchors

Tools:

  • Allen Wrench - 5 Millimeters
  • Drill

How To

Stage 1

Drill Holes

  • First you will want to prepare your shelves. Wood was used in this project.
  • Decide preferred placement for holes the pipe will go through. Measure out where the holes will be drilled and make sure both shelves match.
  • This was made with 3/8” so you will need to drill .68” holes.
  • Drill these holes into the front of each board.

Stage 2

Assembling Shelf

  • Take an 18” pipe and slide it through the drilled holes in the shelf and into an Elbow (682-502HC). Attach a Single Socket Tee (680-102HC) in the other end. Make sure the pipe is sticking out of the Single Socket Tee (680-102HC), based on the thickness of your shelf, and make sure the Single Socket Tee (680-102HC) and Elbow (682-502HC) are facing the same direction then tighten set screws.
  • Attach a 6” pipe to the open end of Elbow (682-502HC) and cap that pipe with a Flange (683-102HC) then tighten set screws.
  • Attach a 6” pipe to open end of Single Socket Tee (680-102HC) and  cap that pipe with a Flange (683-102HC) then tighten set screws.
  • Build this step again repeating the steps making sure to go through other side of board.
  • Place the top shelf boards holes into the pipes sticking out of the Single Socket Tees (680-102HC).

Stage 3

Marking and Drilling Holes

  • Place the fully assembles project against wall and mark the Flange (683-102HC) screw holes for drilling.

Stage 4

Installing Flanges and Shelf

  • Loosen set screws in Flanges (683-102HC) and install Flanges (683-102HC) into wall using wood screws and anchors.
  • Once the Flanges (683-102HC) are installed reattach the shelf to the Flanges (683-102HC) and tighten set screws.