Shot need some work? Build a custom target using SteelTek!
Skill Level
Estimated Cost
Estimated Time
Tools & Materials
SteelTek Supplies (1-1/4"):
(2) Side Outlet Tee - (681-604HC)
(5) 6' Pipe
Other Supplies:
Chain
Nuts and Bolts
Target Substrate
Tools:
Allen Wrench - 8 Millimeter
Socket Wrench
Drill
How To
Stage 1
Building Frame
Feed the 72” horizontal pipe through the through holes of the Single Socket Tees (671-606HC).
Measure about 6” - 12” from the en of the pipe and make sure the fittings are facing the same direction then tighten set screws.
Insert a 72” pipe into each open hole of the Single Socket Tee (671-606HC). There should be two holes in each fitting equaling 4 hole total then tighten set screws.
Measure about 6” - 12” from the en of the pipe and make sure the fittings are facing the same direction then tighten set screws.
Stage 2
Attaching Target
Install target with whatever method works best. In this project a chain was used and secured through the cahin with nuts and bolts.