- Products
-
Projects
- Entryway Shoe Rack
- Stair Railing
- Bicycle Exercise Stand
- Coding Table
- Train Table
- Buffet Table
- Target Range
- Candle Holder
- Decorative Bench
- Outside Bench
- Napkin Holder
- Step Stool
- Fence Wood Rack
- Accessory Holder
- Plant Hanger
- Mail Slot Table
- Coffee Cart
- Bench
- Kitchen Island Rack
- Full Bed
- Gym Hooks
- TV Console
- Bar Top
- Wall Mounted Barbell Rack
- Swivel Table
- Mailbox
- TV Stand
- Console Shelf
- Full Bed
- Towel and Toilet Paper Rack
- Garage Shelf
- Coat Rack
- Stool
- Garage Workbench
- Living Room Table
- Outdoor Railing
- Bookshelf
- Wall Shelf
- Small Shelf
- Entryway Coat Rack
- Decorative Serving Cart
- Serving Station
- Serving Cart
- Corner Desk
- Conference Room Table
- Side Table
- Hallway Table
- Lamp
- Lamps
- Coffee Table
- Decorative Coffee Table
- Worktable
- Blog
- About
- Contact
Products
Projects
Blog
About
Contact
Napkin Holder
Create a new stylish Napkin Holder!
Skill Level
Estimated Cost
Estimated Time
Tools & Materials
SteelTek Supplies (3/8"):
- (2) Flange - (683-102HC)
- (2) Single Socket Tee - (683-102HC)
- (2) End Plug - (688-402HC)
- (3) 6" Non-Threaded Pipe - (582-060PE30HC)
Other Supplies:
- 9" x 9" Wood Piece
- Wood Screws
Tools:
- Drill
- Allen Wrench - 5 Millimeter
How To
Stage 1
Attaching Flanges
- Attach the Flanges (683-102HC) to your wood piece using wood screws.
- Make sure that you are spacing the Flanges (683-102HC) enough so the 6" pipe can fit in between them.
Stage 2
Installing Locker
- Slide a 6" pipe into each Flange then tighten set screws.
- Attach the bottom of a Single Socket Tee (680-102HC) to each end of a 6" pipe. Make sure the vertical holes are not being blocked then tighten set screws.
- Slide the pipe, with the Single Socket Tee's (680-102HC) at the end, down the vertical pipes. You will not be tightening these set screws since this bar will be your holder for the napkins.
Stage 3
Finishing Touches
- Take two End Plugs (688-402HC) and hammer them into the top of each open pipe.