Start by taking an 18” pipe and attaching a Side Outlet Tee (681-604HC) to each side of pipe. You will want both 90-degree openings to face the same direction. Make sure the vertical holes are not blocked, then tighten set screws. Build this step twice.
Take (2) 24” pipes and attach them to the brackets built in the first step. Make sure the vertical holes are not blocked then tighten set screws.
By the end of this Stage you what you built will form a square,
Stage 2
Installing Legs
Take (4) 36” pipe and slide one into each vertical hole of Square built in stage 1.
Measure 10” up and tighten set screws.
Cap the top and bottom of 36” pipes with Flanges (683-104HC) then tighten set screws.
Stage 3
Attaching Top and Middle Shelf
Flip the table and line up the Flanges on the 24” x 36” wood top, Mark the screw holes on the flanges, pre-drill the screw holes then attached Flanges to wood piece using wood screws.
Slide middle piece into open section. This piece does not need to be secure but to secure this piece you can use the Offset Flanges (683-104HC).