SteelTek
SteelTek

Coat Rack

Coat Rack

Clean up your space with this standing Coat Rack. Great for any home or office!

Skill Level
Estimated Cost
Estimated Time

Tools & Materials

SteelTek Supplies (3/4"):

  • (4) 90 Degree Elbow - (672-504HC)
  • (1) Four Socket Cross - (675-804HC)
  • (2) Two Socket Cross - (671-904HC)
  • (2) Hook - (678-204HC)
  • (9) End Plug - (678-404HC)
  • (8) 4" Non-Threaded Pipe
  • (4) 12" Non-Threaded Pipe
  • (1) 72" Non-Threaded Pipe

Tools:

  • (1) Allen Wrench - 6 Millimeters

How To

Stage 1

Stage 1

Installing Legs

  • Take 72" pipe and slide the Four Socket Cross (675-804HC) down pipe until the fitting is around 4" from the bottom of the pipe and tighten sets screw.
  • Slide 12" pipes into each one of the horizontal holes in the Four Socket Cross (675-804HC) and tighten set screws.
  • Attach Elbows (672-504HC) to open ends of each 12" pipe and tighten set screws.
  • Before installing 4" pipes, hammer End Plugs (678-404HC) into one side of 4" pipes.
  • Slide open ends of 4" pipes into open ends of Elbow (672-504HC) and tighten set screws

Steel•Tek Professional Tip

  • When installing the Elbows (672-504HC) make sure the open ends are facing towards the floor.

Stage 2

Stage 2

Attaching Hangers Holders

  • Slide first Hook (678-204HC) down 72" pipe and install it about 28" from the top and tighten set screw.
  • Slide second Hook (678-204HC) down 72" pipe and install it about 24" from the top and tighten set screw.
  • Slide first Two Socket Cross (671-904HC) down 72" pipe and install it about 12" from the top and tighten set screw.
  • Slide second Two Socket Cross (671-904HC) down 72" pipe and install it about 4" from the top and tighten set screw.

Stage 3

Stage 3

Installing Hangers

  • Hammer End Plugs (678-404HC) into one side of x4 4" pipes and into the top of 72" pipe.
  • Slide 4" pipes into each side of Two Socket Cross (671-904HC) and tighten set screws.