Closet System

Closet System

Make extra room for all your clothing!

Skill Level
Estimated Cost
Estimated Time

Tools & Materials

SteelTek Supplies (3/4"):

  • (5) Flange - (673-104HC)
  • (4) Three Socket Tee - (670-404HC)
  • (4) Standard Railing Flange - (673-204HC)
  • (2) Three Socket Cross - (677-604HC)
  • (1) 120" Non Threaded Pipe
  • (2) 80" Non Threaded Pipe
  • (2) 40" Non Threaded Pipe

Other Supplies:

  • (20) Wood Screws

Tools:

  • Allen Wrench - 6 Millimeter
  • Drill

How To

Stage 1

Building Legs

  • Take an 80” pipe and cap the bottom off with a Flange (673-104HC) then tighten set screw.
  • Slide fittings onto pipe in this order. Three Socket Cross (677-604HC) and long slide of Three Socket Tee (670-404HC). Cap the top off with the short side of a Three Socket Tee (670-404HC) and tighten set screw.
  • Measure from the bottom 40” and tighten set screws to the Three Socket Cross (677-604HC). Make sure the side connections are facing the same direction as the side connection of the Three Socket Tee (670-404HC) attached to the top.
  • Measure 12” from the top and tighten set screws of Three Socket Tee (670-404HC). Make sure the open connection is 90-degrees of the open connection of the top Three Socket Tee (670-404HC). This is what will be attached to the wall.
  • Build this twice.

Stage 2

Building Frame

  • Take a 120” pipe and slide through the top Three Socket Tees () of the legs you build in Stage 1.
  • Measure 40” from the left end of the pipe and tighten set screws on the left leg.
  • Measure 40” from the right end of the pipe and tighten set screws on the right leg.
  • Cap each end with a Flange () then tighten set screws.
  • Attach a 40” pipe to the left Three Socket Cross () of the left leg then tighten set screw. Cap the open end of 40” pipe with a Flange (673-104HC) and tighten set screw.
  • Attach another 40” pipe in between both Three Socket Crosses (677-604HC) attached to left and right legs then tighten set screws.

Stage 3

Attaching Flanges to Wall

  • Attached 24” pipes into the middle Three Socket Tees (670-404HC) and the Three Socket Crosses (677-604HC).
  • Cap the 24” pipes off with Standard Railing Flanges (673-104HC) then tighten set screws.
  • Place the structure up against the wall and mark screw holes for in Standard Railing Flanges (673-204HC). Marking the holes and installing them individually will make it easier to attached structure to the wall.

Stage 4

Installing Frame

  • Once Standard Railing Flanges (673-204HC) are installed prop structure slide the pipes in the flanges and tighten set screws.
  • Attached the remaining Flanges (673-104HC) to the wall with wood screws.