Modernize your dinning room with this Candle Holder!
Skill Level
Estimated Cost
Estimated Time
Tools & Materials
SteelTek Supplies (3/4"):
(5) Flange - (673-104HC)
(3) Side Outlet Elbow - (672-804HC)
(2) Elbow - (672-504HC)
(2) 10" Non-Threaded Pipe
(1) 8" Non-Threaded Pipe
(6) 6" Non-Threaded Pipe
Other Supplies:
Glass Holders
Gorilla Glue
Bronze Spray Paint
Tools:
Allen Wrench - 6 Millimeter
How To
Stage 1
Assembling Holders
Start by making sure you have all the above fittings and pipe available.
Take two 6” pipes and attach a Flange (673-104HC) to one end and a Side Outlet Elbow (672-804HC) to the other end then tighten set screws.
Take one 8” pipe and attach a Flange (673-104HC) to one and a Side Outlet Elbow (672-804HC) to the other end then tighten set screws.
Take two 10” pipes and attach a Flange (673-104HC) to one end and an Elbow (672-504HC) to the other end then tighten set screws.
Stage 2
Attaching Holders
Following the diagram above assemble each piece built in stage 1 using 6” pipes and tighten set screws along the way.
Stage 3
Attaching Glass Holders
Attach the glass holders to the Flanges (673-104HC). We were able to find the glass holders at Hobby Lobby and we attached them to the Flanges (673-104HC) using Gorilla Glue.