Projects

Step 1

Legs

• Start with building the legs.
• Grab 3 72” pipes and attach like you see in the above diagram.
• You will want to center the Three Socket Tees (670-404HC) on two pipes and the Two Socket Cross (671-904HC) on the other pipe and tighten the set screws.
• Slide a Gate Eye (673-804HC) on each end pipe and finish 2 legs off with the Elbow (672-504HC) and tighten set screws. Center the Gate Eye (673-804HC) in between the Three Socket Tee (670-404HC) and Elbow (672-504HC) and tighten set screw.
• Finish the middle pipe off with a Side Outlet Tee (671-604HC). Make sure the vertical hole is not being blocked and tighten set screws.
• Attach Flanges (673-104HC) to the bottom of each pipe and tighten set screws.

Step 2

Cross Beams

• This step involves 1 10 ft pipe and 2 5 ft pipes.
• Slide your fittings on in the order you see in above diagram and tighten set screws.
• Make sure the fittings on the 10 ft pipe are set to the left side of the pipe and tighten set screws.

Step 3

Attaching Middle Leg to Wall

• Attach the Flange (673-104HC) to the wall. Make sure you measure appropriately.
• Attach the Flange (673-104HC) and Side Outlet Tee (671-604HC) with an 18” pipe and tighten set screws.

Step 4

Attaching Legs and Cross Beams

• Take the 10 ft pipe built in Stage 2 and slide it into the vertical hole of the Side Outlet Tee (671-604HC).
• Once the 10 ft pipe is centered tighten set screws. Place the fittings on the right hand side of the pipe as shown in above diagram and tighten set screws.
• Attach the two 5 ft pipes built in Stage 2 to the Two Socket Cross (671-904HC)on the middle pipe and tighten set screws.
• Attach the left support to the left side of the 10 ft and 5 ft pipe and tighten set screws.
• Do the same thing on the left hand side and tighten set screws.

Step 5

Finished