Kitchen Island Rack
Build yourself a custom Kitchen Island Rack!
Tools & Materials
SteelTek Supplies (3/4"):
- (4) Black Flange - (683-104HC)
- (10) Black Three Socket Tee - (680-404HC)
- (4) Black Side Outlet Elbow - (682-804HC)
- (8) Black Hooks - (688-204HC)
- (7) 12" Non-Threaded Pipe
- (4) 36" Non-Threaded Pipe
- (2) 44" Non-Threaded Pipe
Other Supplies:
- Wood Screws
- Table Top
Tools:
- (1) Allen Wrench - 6 Millimeters
- Drill
How To
Step 1
Installing Legs
- Start by installing your Flanges.
- Measure the Flanges, place them in the appropriate areas and mark your screw holes.
- Pre-drill screw holes and install flanges using wood screws.
- Slide 36” pipe into each Flange then tighten set screws.
- The two 12” pipes and attach a Three Socket Tee to each end of pipe as shown in above diagram. Make sure the Vertical holes are not being blocked then tighten set screws.
- Take the 12” pipe with Three socket Tees and slide one down the left side and one down the rights side. Set to desirable height then tighten set screws.
Step 2
Building Top
- Take your 44” pipe and slide fittings on in this order: Hook, Three Socket Tee, Hook, Three Socket Tee, Hook, Three Socket Tee, Hook. Space evenly then tighten set screws.
- Take your other 44” pipe and do the same thing.
- Once assembled, take three 12” pipes and attach them to open ends of Three Socket Tees then tighten set screws.
Step 3
Finishing Top
- Take two 12” pipes and attach Side Outlet Elbows to each end as shown in above diagram. Make sure the vertical holes are not being blocked then tighten set screws.
- Slide open horizontal Side Outlet Elbow holes onto open ends of 44” pipe. Make sure the vertical holes are not being blocked then tighten set screws.
Step 4
Installing Top
- Place the top built in Stage 3 onto the vertical pipes by sliding the bottom of the Side Outlet Elbows onto each pipe then tighten set screws.