Projects

Step 1

Building Legs

• Take a 12” pipe and attach an Elbow (682-502HC) to each side of 12” pipe. Make sure the elbows are facing the same direction and tighten set screws
• Slide a 72” pipe into each open end of Elbow (682-502HC) then tighten set screws.
• Do this step 2 times.

Step 2

Building Shelf Supports and Back Supports

• Take (2) 36” pipes and slide (2) Offset Flanges (689-902HC) onto each pipe. Cap each side of 36” pipe with a Side Outlet Tee (681-602HC). Make sure the Side Outlet Tees (681-602HC) are facing the same direction and the vertical hole is not being blocked then tighten set screws.
• Take (2) 12” pipes and slide (1) Offset Flange (689-902HC) onto the 12” pipe. Slide the 12” pipe into the open ends of the Side Outlet Tees (681-602HC) attached to the 36” pipe. Complete these step 5 times.
• Take a 36” pipe and attach a Single Socket Tee (680-102HC) to each side of 36” pipe. Make sure the vertical holes are not blocked in the Single Socket Tees (680-102HC) then tighten set screws. Complete this step 4 times

Step 3

Installing Shelf and Back Supports

• Slide the shelves and back support per instructions.
• Shelf Base, Back Support, Shelf Base, Back Support, Shelf Base, Back Support, Shelf Base, Back Support, Shelf Base.
• Spread these out evenly then tighten set screws.

Step 4

Attaching Flanges and Installing Wood Shelves

• Cap the bottom off with Flanges (683-102HC) then tighten set screws.
• Attach the wood pieces using wood screws.
• Start from the top and go up and through the screw holes of the Offset Flanges (689-902HC). Do this slowly as not to crack the wood pieces.

Step 5

Finish