Coat Rack
Clean up you space with this Coat Rack!
Tools & Materials
SteelTek Supplies (3/4"):
- (4) 90 Degree Elbow - (672-504HC)
- (1) Four Socket Cross - (675-804HC)
- (2) Two Socket Cross - (671-904HC)
- (2) Hook - (678-204HC)
- (9) End Plug - (678-404HC)
- (8) 4" Non-Threaded Pipe
- (4) 12" Non-Threaded Pipe
- (1) 72" Non-Threaded Pipe
Other Supplies:
Tools:
- (1) Allen Wrench - 6 Millimeters
How To
Step 1
Installing Legs
- Take 72" pipe and slide the Four Socket Cross (675-804HC) down pipe until the fitting is around 4" from the bottom of the pipe and tighten sets screw.
- Slide 12" pipes into each one of the horizontal holes in the Four Socket Cross (675-804HC) and tighten set screws.
- Attach Elbows (672-504HC) to open ends of each 12" pipe and tighten set screws.
- Before installing 4" pipes, hammer End Plugs (678-404HC) into one side of 4" pipes.
- Slide open ends of 4" pipes into open ends of Elbow (672-504HC) and tighten set screws
- When installing the Elbows (672-504HC) make sure the open ends are facing towards the floor.
Step 2
Attaching Hangers Holders
- Slide first Hook (678-204HC) down 72" pipe and install it about 28" from the top and tighten set screw.
- Slide second Hook (678-204HC) down 72" pipe and install it about 24" from the top and tighten set screw.
- Slide first Two Socket Cross (671-904HC) down 72" pipe and install it about 12" from the top and tighten set screw.
- Slide second Two Socket Cross (671-904HC) down 72" pipe and install it about 4" from the top and tighten set screw.
Step 3
Installing Hangers
- Hammer End Plugs (678-404HC) into one side of x4 4" pipes and into the top of 72" pipe.
- Slide 4" pipes into each side of Two Socket Cross (671-904HC) and tighten set screws.