Candle Holder
Modernize your dinning room with this Candle Holder!
Tools & Materials
SteelTek Supplies (3/4"):
- (5) Flange - (673-104HC)
- (3) Side Outlet Elbow - (672-804HC)
- (2) Elbow - (672-504HC)
- (2) 10" Non-Threaded Pipe
- (1) 8" Non-Threaded Pipe
- (6) 6" Non-Threaded Pipe
Other Supplies:
- Glass Holders
- Gorilla Glue
- Bronze Spray Paint
Tools:
- Allen Wrench - 6 Millimeter
How To
Step 1
Assembling Holders
- Start by making sure you have all the above fittings and pipe available.
- Take two 6” pipes and attach a Flange (673-104HC) to one end and a Side Outlet Elbow (672-804HC) to the other end then tighten set screws.
- Take one 8” pipe and attach a Flange (673-104HC) to one and a Side Outlet Elbow (672-804HC) to the other end then tighten set screws.
- Take two 10” pipes and attach a Flange (673-104HC) to one end and an Elbow (672-504HC) to the other end then tighten set screws.
Step 2
Attaching Holders
- Following the diagram above assemble each piece built in stage 1 using 6” pipes and tighten set screws along the way.
Step 3
Attaching Glass Holders
- Attach the glass holders to the Flanges (673-104HC). We were able to find the glass holders at Hobby Lobby and we attached them to the Flanges (673-104HC) using Gorilla Glue.
- We finished this off with a bronze spray paint.