Coffee Table

Coffee Table

Easy to build, and very nice looking for any living room!

Skill Level
Estimated Cost
Estimated Time

Tools & Materials

SteelTek Supplies (1-1/4"):

  • (4) Flange - (673-106HC)
  • (4) Side Outlet Elbow - (672-806HC)
  • (2) 12" Non-Threaded Pipe
  • (4) 18" Non-Threaded Pipe
  • (2) 24" Non-Threaded Pipe

Other Supllies:

  • (16) Wood Screws
  • (1) Wood Top 28" x 18"

Tools:

  • (1) Allen Wrench - 8 Millimeters
  • (1) Drill

How To

Stage 1

Installing Flanges

  • Start by installing the flanges on your wood table top. Place the Flanges on the board and mark the flange holes.
  • Pre-drill holes to avoid cracking the wood, then install flanges using wood screws.

Stage 2

Attaching Legs

  • Take 18” pipes (x4) and place one in each installed flange, then tighten set screws.

Stage 3

Building Base

  • Take 24” pipe (x2) and attach a Side Outlet Elbow to each side, then tighten set screws.
  • Take 12” pipe (x2) and attach these to the open horizontal ends of the Side Outlet Elbows, then
    tighten set screws.

Steel•Tek Professional Tip

  • Make sure not to slide the 24” and 12” pipe too far in the Side Outlet Elbows to avoid block the vertical leg holes.

Stage 4

Attaching Base

  • Once you have the base built, slide the 18” legs into the vertical Side Outlet Elbow holes, then tighten set screws.